The main or parent status button operates as it should turning on and off when it is supposed to. I will have to hit it a second time to change the status to off. The first time i hit the button it turns the valve off and reports the status as off and within 2 seconds it changes the status of the relay to on again. The same issue will happen when turning it off. When i hit the button the second time it changes the status to on and stays on. When operating any of the 3 relays in the app i hit the button it will activate the valve and show a status of ‘on’ but within 2 seconds it changes the status back to off. My third issue and the one device i use a ton of routines, or at least used to was for was my Zooz Zen16 for sprinklers. I have not figured out any pattern to this as of now. As well there are times i can be out in the garage with the garage door open and after a significant amount of time it randomly decides to turn the status to closed. So this work around works great using other devices but i cannot change the way the button works in the app. To get it to close properly i choose the “open” action in order to close the door. When i try to create routines to control the garage door from another device, i can only get the control actions Open and Closed (not Close). If i refresh the status when the door shows closed when i hit the button only once and the door is actually open, it correctly changes the status back to open and i will have to hit the button twice to actually close the door. It opens the door and reports the staus correctly but for some reason the button in the SmartThings app does not close the garage door it changes the status of the door to closed and once that is done i have to hit the button a second time to send the “open” signal (since it is a momentary switch action) and then the door will close and report the proper state of the door at that time. The second issue i have is with my Fortrezz MimoLite that i used for a garage door opener. This is the model i have and looking at the fingerprints.yml the manufacture code etc is not in the yml file at all despite it being almost the same as the other KwikSet 914 locks. Factory reset the device and I have even removed all the old device handlers a while back as well. The first issue and the most minor one of the 3 was that i found my Weiser or KwickSet 914 door lock will not install an edge driver of any kind. Everything worked perfectly prior to any edge drivers being installed on my hubs. I am at a loss and cannot find a way to get things to work properly. Now you can be notified if a door is left open, and even receive ongoing reminders until the door is shut, which is great.I have 3 ongoing issues ever since the end of Groovy. I didn’t go into detail in the video about all of these steps in case SmartThings does change it soon. Select it and after clicking done in the SmartApp, Left It Open will be added to the rest of the SmartApps.Īfter doing all these steps once it’s much easier to add more smart apps this way. Scroll to the bottom to see Left It Open. Select the three lines on the left to show the menu. Head over to your SmartThings app on your phone or tablet. Scroll back up and you will see a Create button at the bottom of the area with all of the code. Scroll down and you will see many smart apps available. Then on the top right click on New SmartApp. Smart Apps TutorialĪffiliate Disclosure: This page has affiliate links, which earn us commission at no cost to you.įirst log into your SmartThings account using the browser. Let’s use this example to show how to find and add this extra SmartApp. In my latest video, I give an example of a SmartApp that alerts you when a door is left open. For example, many of the SmartApps in the old Classic app are missing. With SmartThings transitioning everything to their new app, there have been quite a few changes lately. SeptemHow to Add Extra SmartApps in the Updated SmartThings
0 Comments
Leave a Reply. |